From Hentschel
(→Stratux) |
(→/etc/network/interfaces) |
||
| Line 29: | Line 29: | ||
# iface name_of_other_WPA_Config inet dhcp | # iface name_of_other_WPA_Config inet dhcp | ||
## End of interfaces | ## End of interfaces | ||
| + | </pre> | ||
| + | |||
| + | ==== /etc/wpa_supplicant/wpa_supplicant.conf ==== | ||
| + | <pre> | ||
| + | ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev | ||
| + | update_config=1 | ||
| + | |||
| + | network={ | ||
| + | ssid="h**l" | ||
| + | scan_ssid=1 | ||
| + | key_mgmt=WPA-PSK | ||
| + | psk="**********" | ||
| + | priority=1 | ||
| + | } | ||
</pre> | </pre> | ||
=== PiAware === | === PiAware === | ||
* build instructions [https://flightaware.com/adsb/piaware/install at this link] | * build instructions [https://flightaware.com/adsb/piaware/install at this link] | ||
Revision as of 01:37, 19 May 2019
Contents
Stratux
- Stratux build page this link
- Status info at http://stratux/getStatus
/etc/network/interfaces
auto lo
iface lo inet loopback
allow-hotplug eth0
iface eth0 inet dhcp
allow-hotplug wlan0
iface wlan0 inet static
address 192.168.10.1
netmask 255.255.255.0
post-up /usr/sbin/stratux-wifi.sh
wireless-power off
allow-hotplug wlan1
iface wlan1 inet static
wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf
address 192.168.1.98
netmask 255.255.255.0
gateway 192.168.1.1
# iface name_of_WPA_Config inet dhcp
# iface name_of_other_WPA_Config inet dhcp
## End of interfaces
/etc/wpa_supplicant/wpa_supplicant.conf
ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev
update_config=1
network={
ssid="h**l"
scan_ssid=1
key_mgmt=WPA-PSK
psk="**********"
priority=1
}
PiAware
- build instructions at this link