From Hentschel
| Line 8: | Line 8: | ||
'''Important:''' Both sides need to run as root to create the tunnel device. Thus, 'ssh -w 0:0 root@www.hentschel.net' must run as root on the client side too. | '''Important:''' Both sides need to run as root to create the tunnel device. Thus, 'ssh -w 0:0 root@www.hentschel.net' must run as root on the client side too. | ||
| − | < | + | <pre> |
+---------------+ OpenSSH 4.3 +---------------+ | +---------------+ OpenSSH 4.3 +---------------+ | ||
| hentschel | tun0 -- Tunnel Interface -- tun0 | zm.home | | | hentschel | tun0 -- Tunnel Interface -- tun0 | zm.home | | ||
| Line 26: | Line 26: | ||
+---------------+ +---------------+ | +---------------+ +---------------+ | ||
| − | </ | + | </pre> |
| + | |||
| + | To add route from hentschel to Network B, <pre>ip route add 192.168.1.0/24 dev tun0</pre> on 'hentschel' | ||
Revision as of 17:13, 23 March 2017
Setting up VPN via SSHD
from this link
- enable
- PermitTunnel yes
- disable
- AllowTcpForwarding yes
Important: Both sides need to run as root to create the tunnel device. Thus, 'ssh -w 0:0 root@www.hentschel.net' must run as root on the client side too.
+---------------+ OpenSSH 4.3 +---------------+
| hentschel | tun0 -- Tunnel Interface -- tun0 | zm.home |
| Has a tunnel | <------------------------------->| Has a tunnel |
| and ethernet | 10.0.0.100 10.0.0.200 | and ethernet |
+-------+-------+ point to point connection +-------+-------+
eth0 | creates a bridge | eth0
198.57.187.185 | that plugs machine B | 192.168.1.100
Routable | into network A |
address | |
here | |
+-------+-------+ +-------+-------+
| Network A | | Network B |
| The Internet | | 192.168.1.1/24|
| Has internet | | Has internet |
| | | NAT gateway |
+---------------+ +---------------+
To add route from hentschel to Network B, ip route add 192.168.1.0/24 dev tun0on 'hentschel'