From Hentschel
Line 15: | Line 15: | ||
+-------+-------+ point to point connection +-------+-------+ | +-------+-------+ point to point connection +-------+-------+ | ||
eth0 | creates a bridge | eth0 | eth0 | creates a bridge | eth0 | ||
− | 198.57.187.185 | | + | 198.57.187.185 | that plugs machine B | 192.168.1.100 |
− | + | Routable | into network A | | |
− | + | address | | | |
here | | | here | | | ||
− | +-------+-------+ | + | +-------+-------+ +-------+-------+ |
− | | Network A | | + | | Network A | | Network B | |
− | + | | The Internet | | 192.168.1.1/24| | |
− | | Has internet | | + | | Has internet | | Has internet | |
− | + | | | | NAT gateway | | |
− | +---------------+ | + | +---------------+ +---------------+ |
</quote> | </quote> |
Revision as of 22:55, 21 March 2017
Setting up VPN via SSHD
from this link
- enable
- PermitTunnel yes
- disable
- AllowTcpForwarding yes
Important: Both sides need to run as root to create the tunnel device. Thus, 'ssh -w 0:0 root@www.hentschel.net' must run as root on the client side too. <quote>
+---------------+ OpenSSH 4.3 +---------------+ | hentschel | tun0 -- Tunnel Interface -- tun0 | zm.home | | Has a tunnel | <------------------------------->| Has a tunnel | | and ethernet | 10.0.0.100 10.0.0.200 | and ethernet | +-------+-------+ point to point connection +-------+-------+ eth0 | creates a bridge | eth0 198.57.187.185 | that plugs machine B | 192.168.1.100 Routable | into network A | address | | here | | +-------+-------+ +-------+-------+ | Network A | | Network B | | The Internet | | 192.168.1.1/24| | Has internet | | Has internet | | | | NAT gateway | +---------------+ +---------------+
</quote>