Stratux
- Stratux build page this link
- Status info at http://stratux/getStatus
- radios:
- 978 UAT: NESDR Nano2 978, 29ppm (stx:978:29)
- 1090 ES: NESDR Nano2 1090, 28ppm (stx:1090:28)
- change SDR id string for use with stratux:
systemctl stop stratux
-
sdrs
-
rtl_eeprom -d 0 -s <String>:<Freq>:<PPM>
- string format see above
AHRS board
/etc/network/interfaces
auto lo
iface lo inet loopback
allow-hotplug eth0
iface eth0 inet dhcp
allow-hotplug wlan0
iface wlan0 inet static
address 192.168.10.1
netmask 255.255.255.0
post-up /usr/sbin/stratux-wifi.sh
wireless-power off
allow-hotplug wlan1
iface wlan1 inet static
wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf
address 192.168.1.98
netmask 255.255.255.0
gateway 192.168.1.1
# iface name_of_WPA_Config inet dhcp
# iface name_of_other_WPA_Config inet dhcp
## End of interfaces
/etc/wpa_supplicant/wpa_supplicant.conf
ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev
update_config=1
network={
ssid="h**l"
scan_ssid=1
key_mgmt=WPA-PSK
psk="**********"
priority=1
}
PiAware
# Should piaware use the wired ethernet port
# for network access?
wired-network yes
# Wired network configuration:
wired-type static
wired-address 192.168.1.97
wired-netmask 255.255.255.0
wired-broadcast 192.168.1.255
wired-gateway 192.168.1.1
wired-nameservers 192.168.1.2
# Should piaware use a wifi adaptor for network access?
# If you are using a Pi 3, this will use the built-in wifi.
# Otherwise, you will need to attach a supported USB wifi adaptor.
wireless-network yes
# To include quotation marks (") in a quoted value, use \"
# To include a backslash (\) in a quoted value, use \\
wireless-ssid h**l
wireless-password ******
wireless-type dhcp
- add empty file named 'ssh' to boot partition to enable ssh
- get status
sudo piaware-status
sudo systemctl restart piaware
Last modified on 29 May 2019, at 01:00