From Hentschel
* Stratux build page [http://stratux.me this link]
* Status info at http://stratux/getStatus
* radios:
** 978 UAT: NESDR Nano2 978, 29ppm (stx:978:29)
** 1090 ES: NESDR Nano2 1090, 28ppm (stx:1090:28)
* change SDR id string for use with stratux:
** stop stratux service
systemctl stop stratux
:* find radio device number
sdrs
:* write eeprom in radio
rtl_eeprom -d 0 -s <String>:<Freq>:<PPM>
:: string format see above
==== AHRS board ====
* schematics here: https://github.com/stratux/ahrs/blob/master/AHRS.pdf
==== /etc/network/interfaces ====
# iface name_of_other_WPA_Config inet dhcp
## End of interfaces
</pre>
==== /etc/wpa_supplicant/wpa_supplicant.conf ====
<pre>
ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev
update_config=1
network={
ssid="h**l"
scan_ssid=1
key_mgmt=WPA-PSK
psk="**********"
priority=1
}
</pre>
=== PiAware ===
* build instructions [https://flightaware.com/adsb/piaware/install at this link]
* config file in boot:
<pre>
# Should piaware use the wired ethernet port
# for network access?
wired-network yes
# Wired network configuration:
wired-type static
wired-address 192.168.1.97
wired-netmask 255.255.255.0
wired-broadcast 192.168.1.255
wired-gateway 192.168.1.1
wired-nameservers 192.168.1.2
# Should piaware use a wifi adaptor for network access?
# If you are using a Pi 3, this will use the built-in wifi.
# Otherwise, you will need to attach a supported USB wifi adaptor.
wireless-network yes
# To include quotation marks (") in a quoted value, use \"
# To include a backslash (\) in a quoted value, use \\
wireless-ssid h**l
wireless-password ******
wireless-type dhcp
</pre>
* add empty file named 'ssh' to boot partition to enable ssh
* get status
sudo piaware-status
* restart service
sudo systemctl restart piaware