From Hentschel
=== Stratux ===
* Stratux build page [http://stratux.me this link]* Status info at http://stratux/getStatus* radios:** 978 UAT: NESDR Nano2 978, 29ppm (stx:978:29)** 1090 ES: NESDR Nano2 1090, 28ppm (stx:1090:28)* change SDR id string for use with stratux:** stop stratux service systemctl stop stratux:* find radio device number sdrs:* write eeprom in radio rtl_eeprom -d 0 -s <String>:<Freq>:<PPM>:: string format see above ==== AHRS board ====* schematics here: https://github.com/stratux/ahrs/blob/master/AHRS.pdf ==== /etc/network/interfaces ====<pre>auto loiface lo inet loopback allow-hotplug eth0iface eth0 inet dhcp allow-hotplug wlan0iface wlan0 inet static address 192.168.10.1 netmask 255.255.255.0 post-up /usr/sbin/stratux-wifi.sh wireless-power off allow-hotplug wlan1iface wlan1 inet static wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf address 192.168.1.98 netmask 255.255.255.0 gateway 192.168.1.1 # iface name_of_WPA_Config inet dhcp# iface name_of_other_WPA_Config inet dhcp## End of interfaces</pre> ==== /etc/wpa_supplicant/wpa_supplicant.conf ====<pre>ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdevupdate_config=1 network={ ssid="h**l" scan_ssid=1 key_mgmt=WPA-PSK psk="**********" priority=1}</pre>
=== PiAware ===
* build instructions [https://flightaware.com/adsb/piaware/install at this link]
* config file in boot:
<pre>
# Should piaware use the wired ethernet port
# for network access?
wired-network yes
# Wired network configuration:
wired-type static
wired-address 192.168.1.97
wired-netmask 255.255.255.0
wired-broadcast 192.168.1.255
wired-gateway 192.168.1.1
wired-nameservers 192.168.1.2
# Should piaware use a wifi adaptor for network access?
# If you are using a Pi 3, this will use the built-in wifi.
# Otherwise, you will need to attach a supported USB wifi adaptor.
wireless-network yes
# To include quotation marks (") in a quoted value, use \"
# To include a backslash (\) in a quoted value, use \\
wireless-ssid h**l
wireless-password ******
wireless-type dhcp
</pre>
* add empty file named 'ssh' to boot partition to enable ssh
* get status
sudo piaware-status
* restart service
sudo systemctl restart piaware